Posted on

Revival Summer Solstice 2016

Myself and Jim Watt (Author of NOX) will be appearing at Revival Summer Solstice 2016 demonstrating Death Chase / Nox, Galaxy Wars / Space Launcher and previewing my upcoming lightgun games.

The day-ticket giveaway competition is now closed.

Congratulations to the winner, David Dewson.

revival

More Info at : http://www.revivalretroevents.co.uk/

Hopefully see some of you at the show!

Posted on

Vector Clock (Free ROM Download)

Just for fun, I made a simple vector clock for Vectrex. Dont expect the timing to be super accurate but it does stay in sync for quite some time  😉

You can adjust the hour by pressing and holding button1 and holding the joystick in the left or right direction to adjust. Minutes are adjusted in the same way with button 2. Button 3 resets the second hand and button 4 toggles minute/second dots on/off. The clock plays one of 13 different pieces of music every hour.

Free ROM Download :

http://binarystarsoftware.com/bin/VectorClockv102.BIN

Change Log:

v1.02

  • Button 4 now toggles second/minute dots on/off.

v1.01

  • More accurate timing
  • Speed adjust (0-25). Larger values increase clock speed.

v1.00

  • Initial Release
Posted on

DIY Vectrex Light Phaser

Instructions for making your own Sega Light Phaser to Vectrex Lightgun adapter. I’ll be making some of these available with the first lightgun compatible cartridge I produce. Stay tuned for more info 😉

IMG_0493

Parts needed :

1 x Genesis/Atari cable (with all pins connected)

1x DB9 plug

1x DB9 hood

Tools Used :

Soldering iron

Hot Glue gun

Multimeter

IMG_0484

The first job is to test continuity on the pins on the joystick connector with a multimeter to identify which coloured wires to use.

Vectrex Controller Pinout www.gamesx.com/controldata/vectrex.htm
Sega Light Phaser Pinout
segaretro.org/Light_Phaser#Pinout
Pin Mapping

SMS Pin 7 (Light sensor) to Vectrex Pin 4 (Button 4)
SMS Pin 6 (Trigger) to Vectrex Pin 3 (Button 3)
SMS Pin 5 (+5v) to Vectrex Pin 7 (+5v)
SMS Pin 8 (GND) to Vectrex Pin 8 (GND)

On the cable I used the wires are as follows :

Yellow : Light Sensor

Orange/Peach : Trigger

Grey : +5v

Black : GND

Next we isolate these wires and strip them for soldering to the plug.

IMG_0485

On the plug, we solder to pins 5,6,7 and 8 using the pin mapping listed above.

IMG_0487

Once soldering is complete, you should attach the DB9 hood and test the lightgun is working on the Vectrex. You may need to cut away part of the plastic connector with a craft knife to allow the connector to properly insert into the Vectrex. If you are unsure how to cut it, refer to the standard Vectrex connector shape.

IMG_0490

If it is not working as expected, check pin-mapping and continuity with a multimeter and correct any mistakes made.

If working successfully with Vectrex, remove the top of the DB9 hood, add hot glue to hold the connections and attach the hood again.

IMG_0488

Leave the glue to solidify for a few hours and then enjoy your new lightgun adapter!

IMG_0489

 

Some of the forthcoming lightgun (and lightpen) compatible games are previewed in VectrexRoli’s video below :